A lot of the eurovan blogs out there end up having a new switch plate of some sort! Times change and we need new fuctions. After getting mine, I originally modified the original by cutting in a couple of switches for the fridge and fitting 12V, USB chargning and a switch in place of the redundant 110v outlets.
My issue with this set up was primarilly that the USB and 12v cables were by the opening part of the fridge door, which always lead to cables trapped in the door. I could have re-hinged the door but the door was correct as the passenger could open it and get at drinks while we were moving. I also didn’t have a switch setup for my router (which lives under the sink)
![](http://dazedproductions.co.uk/Vanity/photos/switchpanel/Plate1.jpg)
The secondary issue is that in these coronavirus times the van is my shed office. To plug in my laptop I currently have to plug in USB-C into a modified cigarette lighter unit and plug that into my 12v outlets. It is not only a bit ungainly but I also keep running out of outlets on this side of the van (using another for wifi link and another for a NUC). I wanted to install a modified USB-C adapter
I started CADing up the plate probably 2 years ago and it got re-picked up every now and again. Everytime slightly different. I wanted to get a proffesionally made plate from the cad made out of metal but getting someone to do it was problematic. In the end I gave up. Something composite and home made is a bit more in keeping with the van anyway!
Made some carbon fibre plate and transfered all the measurements from my cad to the plate by hand. Took my time and tried to get all the holes as accurate as possible with a handheld drill and a dremel. Should really use a pillar drill but I have too many tools for my flat as it is! One of the nice things of composites is they are a lot easier to cut than metal.
Not sure what everyone else finds but my Winnebago framework is far from square. Plate had to be taller on the left to the right. My plate also has a straight line from one side to the other, which shows the bow in the metal work! Its also not flat as they never bothered to sand down the welds. . .
Left to right my plate ends up with
- 2 x 12v direct power outlets on Lemo 1B
- Switched Dual USB A power outlets with volt meter. Dual USB-C outlets with top delivering 30w for laptops, lower 18w for phones etc. (Its a pass through connector connected to an Anker charger modified to convert from cigarette lighter to cable input)
- Gap for future sockets
- Locking power switch for van 4G wifi router and associated bits
- Fridge power
- Livello 9-LED LPG monitor
- Stock test switch
- Stock levels board but with LED holes for water only
- Water pump switch
I was tempted to get rid of the factory meters completly but seemed silly to chuck it away when i would have to recreate its functions for the water. The voltage and LPG are now hidden away as they serve no function any more.